網站首頁 關于我們 新聞中心 企業榮譽 產品展示 銷售業績 下載中心 人才招聘 聯系我們
HBM-S中央鏈提升機
HBM-D中央鏈提升機
HBC型熟料鏈斗機
HBE型膠帶提升機
HBN大型板式鏈條斗式提升機
NE 提升機
NSE 提升機
FU鏈式輸送機
主要配件-鏈條
主要配件-鏈輪
   您當前的位置:首頁 - 產品中心
 HBE型膠帶提升機 >> HBE型膠帶提升機
  宏基輸送的鋼絲繩芯膠帶提升機 HBE型
 
輸送能力超過每小時 1200噸  
   相臨近的兩個料斗間的間距較短,料斗的容積較大,運行速度較快,使的設備輸送能力大大提高,最大輸送能力可超過 1200噸/小時。 ( With a small bucket spacing and large bucket volume, the elevator runs rapidly and its conveying capacity is significantly increased, with the max. conveying capacity exceeding 1200T/H. )
提升高度可超過 120米  
   采用配有比較非常輕便的鋼絲繩芯的膠帶,運行非常迅速, 可使設備提升高度可超過 120米 (

With light wire mesh belt used for it, thiselevator runs at high speed and transports materials over a height of 120m . )

配有分瓣式的頭輥
   提升機的頭部滾筒的特殊人性化設計,使膠帶在運行過程中自動找正,防止跑偏;而且頭部滾筒采用分瓣鑲嵌式包膠,使得維修、更換工作非常簡單,維護費用大大降低; ( With special ergonomic design of the elevator head rollers, the belt is self-aligned during peration, which prevents belts from running off center. The head rollers are split inlaying ubber-lined rollers which allow easy and simple maintenance and replacement and considerably reduce maintenance cost. )

配有柔性張緊裝置的鼠籠式尾輥

  尾部協調式自動張緊特殊設計的膠帶連接接頭和料斗固定件,使膠帶在運行中不脫開、不撕(斷)裂,大大提高膠帶的使用壽命;提升機的尾部滾筒采用輪條式設計,有效排出附著在膠帶上的物料,延長膠帶的使用壽命;鼠籠式尾輥尾部軸承座采用嚴格可靠的接觸性密封件;
頭尾防跑偏是通過頭尾滾面的鼓形結構來保證的,如客戶需要還可配置防偏傳感器進行保護,尾部平衡是靠張緊絲桿和配重來完成;打孔對鋼絲繩芯膠帶的強度影響已經在膠帶的強度計算中考慮在內;
底部料位指示通過料位傳感器完成的,安裝方式采用裝配式安裝。( Equipped with specially-designed belt joints and bucket fasteners at tail section that has automatic take-up, the belt will not come off or break up during operation and thus its service life is increased significantly. Elevator tail rollers have wheel-spoke design so as to effectively discharge the materials adhered to the belt, and extend the service life of belts. The squirrel-cage tail rollers and bearing pedestal are fitted with extremely reliable contacting seals.
Drum units on the roller surface in head and tail sections ensure to prevent the belt from running off center. If customers think necessary, we can provide a defection sensor for protection, and tail balancing is completed by threaded tensioning bar and counterweights. Impacts of drilling on the strength of wire mesh belt has been taken into account when calculating the belt strength.
Material level indication at the bottom is provided by the level sensor, which is assembled. )


點擊數:291  錄入時間:2009/3/6 【打印此頁】 【關閉
     | 關于我們 | 聯系方式 | 客戶留言 | 人才招聘 | 相關知識 | 友情鏈接 |                   版權所有(2013-2015) 杭州宏基輸送機械有限公司 備案號:浙ICP備05051661號
江苏北京快三